Pressure-Seal is an internal repair sleeve designed for pressure
pipe joint and pin-holes repair.
Pressure-Seal seals pressure pipe joints and pin-holes with ultimate pressure
up to 150 psi. (10 bar). For higher pressures contact
Link-Pipe at 1-800-265-5696.
in a 12" Pipe
The sleeve core is made of
stainless steel SST-316 with internal locking mechanism. Outside
gasket is saturated with sealant that is mechanically pressed against
the host pipe when sleeve is expanded and locked in place. The
sealant is ambient temperature cured and seals the sleeve in
place creating a mechanical bond by filling surface roughness as
well as chemical adhesion, thus sealing the
joints and pin holes.
Sleeves are available in diameters ranging from 4" (100mm) to
54" (1350mm) with standard lengths of 12" (300mm),
18" (450mm), 24" (600mm) and 36" (900mm)
|Pressure-Seal provides long-term seal of leaks using mechanically
locked stainless steel combined with resin sealer.
||Pressure-Seal seals leaking,
separated, misaligned and offset joints and pin-holes in pressure pipes with ultimate pressure
up to 150 psi. (10 bar).
Pressure-Seal can seal leaking
pipes with operational temperature up to
200°F (93°C). Ask Link-Pipe
for additional information.
Standard Pressure-Sealis made
of stainless steel expandable core covered with sealing material.
are equipped with Ratchet Lock mechanism to accommodate
dimensional tolerances of the host pipe up to +/- 1/2-inch. Pressure-Seal is
designed for sealing pressure pipes and it is uniquely suitable for
old cast iron mains that have unpredictable variations in manufacturing
tolerances, -roundness and -joint offsets to which the sleeve will conform.
comes supplied with all required ingredients for complete repair.